![]() The nice thing about powder coat is that you can effectively grind a bit on the fin edges and then wire brush them with a dremmel tool to polish. like the center of the points cover and the edge of the clutch cover. I decided to clean up the side covers and do a bit of trim paint in black. I have already had the valve cover done flat black. I had the cases, block and cylinder head done. I am currently getting some bits on my project KZ1000E1 ST (shaft) powdercoated using semi-gloss wrinkle finish (mild wrinkle). The block and side covers on the other hand would probably do well to be bake-cured I would guess. I like to use aluminum Hi-Temp on my blocks and cylinder heads in general after clean up. In other words, it works OK on a cylinder or cylinder head but not so well on side covers and engine cases which don't get as warm. High Temp engine paint does OK if it is cured.
0 Comments
Leave a Reply. |